Garmin SA01535Wi_D Guía de usuario Pagina 145

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 152
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 144
Garmin G1000 Cockpit Reference Guide for the Beechcraft 200/B200 Series
190-00929-03 Rev. A
Appendix
129
Flight
Instruments
Nav/Com/
XPDR/Audio AFCS GPS Nav
Flight
Planning Procedures
Hazard
Avoidance
Additional
Features Annun/Alerts Appendix Index
6)
Turn the system OFF and remove the SD card from the top card slot.
7)
Repeat steps 1 through 6 for the other displays (PFD1, PFD2 or MFD).
8)
Apply power to the system and press the ENT Key to acknowledge the startup
screen.
9)
Turn the large FMS Knob to select the AUX Page group on the MFD.
10)
Turn the small FMS Knob to select the System Status Page.
11)
Press the Display Database Selection Softkey to show active navigation
database information for each display (MFD1 DB, PFD1 DB, PFD2 DB). Verify
the correct active navigation database cycle information is shown for each
display.
Loading the Jeppesen Navigation Database as the Standby Navigation
Database
NOTE: After the navigation database is loaded or copied, the top SD card
may be removed.
1)
With the system OFF, insert the SD card containing the new navigation
database version into the top card slot of the MFD.
2)
Verify that an SD card is inserted in the bottom slot of each PFD and the
MFD.
3)
Turn the system ON. A prompt is displayed.
4)
Press the YES Softkey. The navigation database is copied to the SD card in
the bottom card slot of the MFD.
5)
After the navigation database files are copied to the bottom SD card, press
any key to continue, as instructed.
7)
Again, press any key to continue as instructed on the display.
8)
Press the NO Softkey. The display now starts in normal mode. Since the
database effective date is not yet valid, it should not be loaded as the
active database. The display now starts in normal mode. Do not remove
power while the display is starting.
9)
Press the ENT Key to acknowledge the startup screen.
10)
Turn the large FMS Knob to select the AUX Page group on the MFD.
11)
Turn the small FMS Knob to select the System Status Page.
Vista de pagina 144

Comentarios a estos manuales

Sin comentarios