Garmin Software Version 0764.09 Guía de usuario Pagina 134

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 142
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 133
Cirrus Perspective
by Garmin – Cockpit Reference Guide for the SR20/SR22/SR22T
190-00821-06 Rev. A
Appendix
118
Flight
InstrumentsEIS
Nav/Com/
XPDR/AudioAFCSGPS Nav
Flight
PlanningProcedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
AlertsAppendixIndex
8)
Make sure the SYNC DBS Softkey is in the enabled state.
9)
Monitor the Sync Status in the Database Window. Wait for all databases to
complete synching, indicated by ‘Complete’ being displayed.
10)
Remove and reapply power to the system.
11)
Turn the large FMS Knob to select the AUX Page group on the MFD.
12)
Turn the small FMS Knob to select the System Status Page.
13)
Press the Display Database Selection Softkey to show database information
for each display (MFD1 DB, PFD1 DB). Verify the correct database cycle
information is shown for each database for each display.
Loading the Jeppesen Navigation Database as the Active Navigation
Database
NOTE: Loading the Jeppesen navigation database as the active database
prior to its effective date will result in the expiration date on the power-up
screen and the effective date on the AUX-System Status Page being displayed
in yellow.
1)
With the system OFF, insert the SD card containing the new navigation database
version into the top card slot of the display (PFD or MFD) to be updated (label
of SD card facing left).
2)
Turn the system ON. A prompt similar to the following is displayed in the upper
left corner of the display:
3)
Press the NO Softkey to proceed to loading the active database.
4)
A prompt similar to the following is displayed. Press the YES Softkey to update
the active navigation database.
5)
After the update completes, the display starts in normal mode.
6)
Turn the system OFF and remove the SD card from the top card slot.
7)
Repeat steps 1 through 6 for the other display (PFD or MFD).
8)
Apply power to the system and press the ENT Key to acknowledge the startup
screen.
9)
Turn the large FMS Knob to select the AUX Page group on the MFD.
10)
Turn the small FMS Knob to select the System Status Page.
11)
Press the Display Database Selection Softkey to show active navigation
database information for each display (MFD1 DB, PFD1 DB). Verify the
correct active navigation database cycle information is shown for each display.
Vista de pagina 133

Comentarios a estos manuales

Sin comentarios