Garmin 2006T Guía de usuario Pagina 73

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 348
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 72
190-01146-00 Rev. A
Garmin G950 Pilot’s Guide for the Tecnam P2006T
61
FLIGHT INSTRUMENTS
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICES INDEX
Changing navigation sources:
1) Select the CDI Softkey to change from GPS to VOR1 or LOC1. This places the light blue tuning box over the
NAV1 standby frequency in the upper left corner of the PFD.
2) Select the CDI Softkey again to change from VOR1 or LOC1 to VOR2 or LOC2. This places the light blue tuning
box over the NAV2 standby frequency.
3) Select the CDI Softkey a third time to return to GPS.
Figure 2-25 Selecting a Navigation Source
NAV1 Selected for Tuning
LOC1
Selected
LOC2
Selected
NAV2 Selected for Tuning
CDI
Softkey
Cycles Through
Navigation Sources
GPS
Selected
The system automatically switches from GPS to LOC navigation source and changes the CDI scaling accordingly
when all of the following occur:
•AlocalizerorILSapproachhasbeenloadedintotheactiveightplan
•Thenalapproachx(FAF)istheactiveleg,theFAFislessthan15nmaway,andtheaircraftismoving
toward the FAF
•Avalidlocalizerfrequencyhasbeentuned
•TheGPSCDIdeviationislessthan1.2timesfull-scaledeection
GPS steering guidance is still provided after the CDI automatically switches to LOC until LOC capture, up
to the Final Approach Fix (FAF) for an ILS approach, or until GPS information becomes invalid. Activating
a Vector-to-Final (VTF; see the Flight Management Section) also causes the CDI to switch to LOC navigation
source; GPS steering guidance is not provided after this switch.
Vista de pagina 72
1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 347 348

Comentarios a estos manuales

Sin comentarios