
Garmin G1000 Cockpit Reference Guide for the Diamond DA62
190-01896-00 Rev. A
Appendix
123
Flight
Instruments EIS
Nav/Com/
XPDR/Audio AFCS GPS Nav
Flight
Planning Procedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
Alerts Appendix Index
If an error occurs during synchronization, an error message will be displayed,
followed by the affected display in the Sync Status section of the Database Window. If
synchronization completes on one display, but an error occurs on another, the error
message will be displayed with the affected displays listed after it. When an error
message is displayed, the problem must be corrected before synchronization can be
completed. A power cycle is required to restart synchronization when ‘Card Full’ or
‘Err’ is shown.
Error Message Description
Canceled Database synchronization has been canceled by removing the
bottom SD card in display being updated
Card Full SD card does not contain sufficient memory
Err Displayed for all other errors that may cause the synchronization
process to be halted
Timeout System timed-out prior to the database transfer completing
Updating Basemap, SafeTaxi, Airport Terrain, Obstacle, and Airport
Directory Databases
These databases may be copied to one Supplemental Data Card, then automatically
synchronized to other card in the system:
1)
With system power OFF, remove the MFD database card from the bottom
card slot of the MFD.
2)
Update the basemap, SafeTaxi, airport terrain, obstacle and/or airport
directory databases on the MFD card.
3)
Insert the MFD database card into the bottom card slot of the MFD.
4)
Apply power to the system, check that the databases are initialized and
displayed on the power-up screen. If a ‘Verifying’ message is seen, wait for
the system to finish loading before proceeding to step 5.
5)
Acknowledge the Power-up Page agreement by pressing the ENT Key or
the right most softkey.
6)
Turn the large FMS Knob to select the AUX Page group on the MFD.
7)
Turn the small FMS Knob to select the System Status Page.
8)
Monitor the Sync Status in the Database Window. Wait for all databases to
complete synching, indicated by ‘Complete’ being displayed.
Comentarios a estos manuales