Garmin TR-1 Guía de inicio rápido descargar pdf (Pagina 1)

TR-1 Gold Owner’s Handheld Quick Reference

Click to go from Standby to Autopilot mode.

To engage GPS push and release [GPS Track] button

(Must plot a waypoint, route or steer to cursor).

To autopilot in reverse: 1) Start from Standby 2) Press and

hold the [GPS REV] button 3) Press and release the [Auto/

Stby] button 4) Release the [GPS REV] button.

For Man Overboard Maneuver press and release the

[MOB] button. (Williamson Turn)

Idle Resume

(Factory Default)

, Zig-Zags.

Step Turns, Circles, and Remote Steer to port when

NOT in GPS Mode.

Orbit, Clover Leaf and Search to Port

when IN GPS Mode.

Press and hold the [SETUP] Button to see

what your buttons are set at.

To change from Idle/Resume to MOB you would: Press and hold [SETUP], then press the [MOB] button

twice, you will see the light change from #2 to #1.

Step Turns, Circles and Remote Steer to Starboard

when NOT in GPS Mode.

Orbit, Clover Leaf and Search to Starboard when

IN GPS Mode.

For further assistance please call technical support at 1-866-559-0229

Increase throttle by pressing the [Up Arrow] button.

Decrease throttle by pressing the [Down Arrow] button.

The electric throttle runs in parallel with the tiller throttle,

this means that you can’t reduce the RPM with the electric

throttle if the tiller throttle is set high. It is best to always

run with the tiller throttle set to idle.

Note: Boat Hydraulics too active, but the boat holds course? Try adjusting the Sea State Filter. This is adjustable at four levels, (1-4) factory default is set at the most active

(4). Press and release the [Setup] button, press the 1,2,3 button once to light up code #1, decrease this function by pressing the down arrow button until the setting is most

comfortable for your use. If you wish to save this setting, Press and Hold the [Select Load] button while pressing and releasing the deckmount On/Off switch.

907-0002-00

1 2

Indice de contenidos

Pagina 1 - 907-0002-00

TR-1 Gold Owner’s Handheld Quick ReferenceClick to go from Standby to Autopilot mode. To engage GPS push and release [GPS Track] button (Must

Pagina 2 - How to use Pattern Steering

TR-1 Gold Owner’s Handheld Quick ReferenceHow to Change the Values of the Parameters1. Press and release the Setup Button.2. Using the codes below, Ma