Garmin GHP 20 System for Yamaha Helm Master Manual de instalación descargar pdf (Pagina 4)

4 GHP 20 Installation Instructions



The NMEA 2000 cables connect the CCU and the GHC 20 to the

NMEA 2000 network. Either connect the CCU and the GHC 20 to an

existing NMEA 2000 network using the included T-connectors and drop

cables, or use all of the included NMEA 2000 cables and connectors to

build a NMEA 2000 network on your boat if needed (page 8).

➊

➋

➌ ➍ ➎

➊

NMEA 2000 drop cable, 6 ft. (2 m) (×2)

➋

NMEA 2000 power cable

➌

NMEA 2000 T-connector (×3)

➍

NMEA 2000 terminator, male

➎

NMEA 2000 terminator, female



NMEA 2000 extension cables are available if needed. Contact

your local Garmin dealer or Garmin Product Support for ordering

information.



• Safety glasses

• Drill and drill bits

• 3

in. (90 mm) hole saw

• Wire cutters/strippers

• Phillips and at screwdrivers

• Cable ties

• Waterproof wire connectors (wire nuts) or heat-shrink tubing and a

heat gun

• Marine sealant

• Portable or handheld compass (to test for magnetic interference

when determining the best location to install the CCU)

• Anti-seize lubricant (optional)

NOTE: Mounting screws are provided for the GHC 20 and the CCU. If

the provided screws are not appropriate for the mounting surface, you

must provide the correct types of screws.

1 2 3 4 5 6 7 8 9 ... 19 20

Sin comentarios

Garmin GHP 20 System for Yamaha Helm Master Manual de instalación Pagina 4