
GPSMAP 400/500 Series Owner’s Manual 45
Conguring the Chartplotter
To enable or disable NMEA 0183 output sentences:
1. From the Home screen, select Congure > Communications >
NMEA 0183 Setup.
2. Select a setting (Sounder, Route, System, or Garmin).
3. Select the NMEA 0183 output sentence to toggle the output on or
off.
• —adjust the number of digits (,
, or ) to the right of the decimal point
for transmission of NMEA output.
• —determine how the unit identies waypoint
identiers (or ).
—lists the NMEA 2000 devices on your
network. If a NMEA 2000 device has conguration options or
settings, select the device for a list of options.
Only the following units are NMEA 2000 compatible:
GPSMAP 441/441s GPSMAP 536/536s
GPSMAP 541/541s GPSMAP 546/546s
—lists the CANet devices on your network. If a
CANet device has conguration options or settings, select the device
for a list of options.
Only the GPSMAP 430/440/530/540/535/545 (including “s”
models) are CANet compatible.
Setting Alarms
You can set the unit to sound an audible alarm when certain
conditions are met. By default, all alarms are turned off.
To set an alarm:
1. From the Home screen, select Congure > Alarms.
2. Select an alarm category.
3. Select an alarm.
4. Select On to turn on the alarm.
5. Specify alarm information.
Setting Navigation Alarms
To set a navigation alarm from the Home screen, select >
> .
—set an alarm to sound when you are within a specied
distance or time from a turn or destination waypoint.
• —select whether you want arrival alarms to sound only
when nearing destinations or when nearing either turns or
destinations. Select to disable arrival alarms.
• —select whether the arrival alarm triggers on time to
arrival or distance to arrival.
Comentarios a estos manuales