Garmin Software Version 0508.10 Guía de usuario Pagina 60

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 102
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 59
Garmin G1000 Cockpit Reference Guide for the Beechcraft 58/G58
190-00526-01 Rev.B
44
Hazard Avoidance
Flight
InstrumentsEIS
Nav/Com/
XPDR/AudioAFCSGPS Nav
Flight
PlanningProcedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
AlertsAppendixIndex
enters Standby Mode. After the aircraft is airborne, press the WEATHER
Softkey.
Or
:
If the aircraft is already airborne, press the WEATHER or GROUND Softkey.
The one-minute warm-up period is initiated, after which the radar begins
transmitting. The horizontal scan is initially displayed.
5)
Turn the Joystick to select the desired range.
6)
If desired, press the VERTICAL Softkey for vertical scanning.
Adjusting Antenna Tilt
Move the
Joystick
up or down to adjust the tilt of the antenna up or down. Moni-
tor the displayed tilt value in the TILT field.
When scanning vertically, a Tilt Line may be displayed to aid in positioning the tilt
of the antenna. If the Tilt Line is not displayed, perform the following steps:
1)
Press the MENU Key
2)
Turn the large FMS Knob to select ‘Show Tilt Line’.
3)
Press the ENT Key.
Adjusting Antenna Bearing
Move the
Joystick
right or left to adjust the azimuth position of the antenna right
or left. Monitor the displayed bearing value in the BEARING field.
When scanning horizontally, a Bearing Line may be displayed to aid in positioning
the antenna for the vertical scan. If the Bearing Line is not displayed, perform the
following steps:
1)
Press the MENU Key
2)
Turn the large FMS Knob to select ‘Show Bearing Line’.
3)
Press the ENT Key.
Vertically Scan a Storm Cell
1) While in the Horizontal Scan view, move the Joystick to place the Bearing
Line on the desired storm cell, or other area, to be vertically scanned.
2)
Press the VERTICAL Softkey. A vertical ‘slice’ of the selected area is now
displayed.
3)
Move the Joystick right or left to move the scanned “slice” a few degrees
right or left.
Vista de pagina 59
1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 101 102

Comentarios a estos manuales

Sin comentarios