Garmin Software Version 0829.00 Guía de usuario Pagina 124

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 132
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 123
Garmin G1000 Cockpit Reference Guide for the Socata TBM 700
190-01247-00 Rev. A
Appendix
108
Flight
InstrumentsEAS
Nav/Com/
XPDR/AudioAFCSGPS Nav
Flight
PlanningProcedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
AlertsAppendixIndex
8)
Monitor the Sync Status in the Database Window. Wait for all databases to
complete synching, indicated by ‘Complete’ being displayed.
9)
Remove and reapply power to the system.
10)
Turn the large FMS Knob to select the AUX Page group on the MFD.
11)
Turn the small FMS Knob to select the System Status Page.
12)
Press the Display Database Selection Softkey to show database information
for each display (MFD1 DB, PFD1 DB, PFD2 DB). Verify the correct
database cycle information is shown for each database for each display.
Loading the Jeppesen Navigation Database as the Active Navigation
Database
NOTE: Loading the Jeppesen navigation database as the active database
prior to its effective date will result in the expiration date on the power-up
screen and the effective date on the AUX-System Status Page being displayed
in yellow.
NOTE: After the navigation database is loaded or copied, the top SD card
may be removed.
1)
With the system OFF, insert the SD card containing the new navigation database
version into the top card slot of the display (PFD1, PFD2 or MFD) to be updated
(label of SD card facing left).
2)
Turn the system ON. A prompt is displayed in the upper left corner of the
display:
3)
Press the NO Softkey to proceed to loading the active database.
4)
A prompt similar to the following is displayed. Press the YES Softkey to update
the active navigation database.
5)
After the update completes, the display starts in normal mode.
6)
Turn the system OFF and remove the SD card from the top card slot.
7)
Repeat steps 1 through 6 for the other displays (PFD1, PFD2 or MFD).
8)
Apply power to the system and press the ENT Key to acknowledge the startup
screen.
9)
Turn the large FMS Knob to select the AUX Page group on the MFD.
10)
Turn the small FMS Knob to select the System Status Page.
Vista de pagina 123

Comentarios a estos manuales

Sin comentarios