
Garmin G1000 Cockpit Reference Guide for the DA42
190-00406-05 Rev. B
4-6
SECTION 4 – NAV/COM &
TRANSPONDER
Manual Code Entry
1) Press the
XPDR
Softkey to display the
transponder Mode Selection softkeys.
2) Press the
CODE
Softkey to display the
transponder Code Selection softkeys, which
includes the digit softkeys.
3) Press the appropriate digit softkeys to enter
the code in the four-digit code field of the
Transponder Status Box. Five seconds after the
fourth digit has been entered, the transponder
code becomes activated.
When entering a code, press the
BKSP
Softkey
as needed to back up and change code
digits.
Following is a list of important codes:
• 1200 – VFR code in the U.S. (please refer to the
ICAO standards for VFR codes in other countries).
• 7000 – VFR code commonly used in Europe
(please
refer to the ICAO standards).
• 7500 – Hijack code.
• 7600 – Loss of communication code.
• 7700 – Emergency code.
• 7777 – Military interceptor operations code
(NEVER ENTER THIS CODE).
• 0000 – Code for military use (in the U.S.).
Flight ID Reporting
If so configured, the Flight ID may be entered in the
Timer/Reference Window.
Figure 4-13 Timer/References Window
Flight ID
PFD Entry
1) Press the
TMR/REF
Softkey to display the Timer/
References Window.
2) Turn the large
FMS Knob to place the cursor in the
Flight ID field.
3) Turn the small
FMS Knob to enter the desired first
character.
4) Turn the large
FMS knob to place the cursor in the
next desired field.
5) Turn the small
FMS Knob to enter the next desired
character.
6) Repeat steps 4 and 5 until the desired Flight ID is
entered.
7) Press the
ENT Key. ‘updating’ will be displayed as
the Flight ID is loaded into the system.
Comentarios a estos manuales