Garmin Software Version 0734.23 Guía de usuario Pagina 153

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 160
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 152
Cockpit Reference Guide for the Prodigy
Flight Deck 300
190-00761-00 Rev. A
Appendix
137
Flight
Instruments EAS
Nav/Com/
XPDR/Audio AFCS GPS Nav
Flight
Planning Procedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
Alerts Appendix Index
AUTOMATIC DATABASE SYNCHRONIZATION
The automatic database synchronization feature automatically transfers the
databasefromasingleSDdatabasecardtotheSDcardsoneachPFDandtheMFDto
ensure that all databases are synchronized throughout the system. After power-up, the
Prodigy
system compares all copies of each applicable database. If similar databases
do not match, the most recent valid database is automatically copied to each card in
the system that does not already contain that database.
NOTE:
The9-arcsecondterraindatabasemaytakeaslongas100minutesto
synchronize using this method. Therefore the user may want to transfer the
data using a PC, or connect the Prodigy
system to a ground power source while
performing the database synchronization.
Synchronizing Databases
1)
Remove the MFD database card from the bottom card slot of the MFD.
2)
Update the Garmin databases on the MFD card.
3)
Insert the MFD database card into the bottom card slot of the MFD.
4)
Apply power to the system, check that the databases are initialized
and displayed on the power-up screen. When updating the terrain and
FliteCharts databases, an ‘in progress’ message may be seen. If this
message is present, wait for the system to finish loading before proceeding
to step 5.
5)
Acknowledge the Power-up Page agreement by pressing the ENT Key or
the right most softkey.
6)
Turn the large FMS Knob to select the AUX Page group on the MFD.
7)
Turn the small FMS Knob to select the System Status Page.
8)
If necessary, select the SYNC DBS Softkey so it is enabled.
9)
A YES/NO prompt is displayed.
10)
With ‘YES’ highlighted, press the ENT Key.
11)
Monitor the Sync Status in the Database Window, wait for all databases to
complete synching.
12)
Remove and reapply power to the system, select the AUX-System Status
Page, and verify that all databases have been synchronized.
Vista de pagina 152

Comentarios a estos manuales

Sin comentarios