Garmin Software Version 0734.27 Guía de usuario Pagina 86

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 174
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 85
Cockpit Reference Guide for the Prodigy
®
Flight Deck 300
190-00761-01 Rev. A
70
Additional Features
Flight
InstrumentsEAS
Nav/Com/
XPDR/AudioAFCSGPS Nav
Flight
PlanningProcedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
AlertsAppendixIndex
Registering the System for Data Link Services
1)
With the Prodigy
®
system connected to a Wi-Fi network, turn the large FMS
Knob on the MFD to select the AUX page group.
2)
Turn the small FMS Knob to select SYSTEM STATUS. The AUX-SYSTEM
STATUS Page is displayed. Note the System ID number in the AIRFRAME
field as seen in Figure 8-72. This number will be needed when contacting
Garmin Flight Data Services to establish the account.
3)
Turn the small FMS Knob to select REPORTS/DATA LINK.
4)
If necessary, select the REPORTS Softkey. The AUX-REPORT STATUS Page is
now displayed.
5)
Press the MENU Key. The Page Menu window is now displayed.
6)
Select ‘Register With GFDS’ in the menu list.
7)
Press the ENT Key. The Garmin Flight Data Service Registration window is
now displayed.
8)
Enter the Access Code provided by Garmin Flight Data Services.
9)
Press the ENT Key. REGISTER will now be highlighted.
10)
Press the ENT Key. System registration is complete when ‘REGISTERED’
is displayed in the STATUS field. Verify the information displayed in the
CURRENT REGISTRATION window is correct.
Disable/Enable Iridium Transceiver
Iridium telephone and data communications may be turned on or off by performing
these simple steps.
Disable/Enable Telephone and Low Speed Data Services:
1)
Turn the large FMS Knob on the MFD to select the AUX page group.
2)
Turn the small FMS Knob to select REPORTS/DATA LINK.
3)
If necessary, select the REPORTS Softkey. The AUX-REPORT STATUS Page is
now displayed.
4)
Press the MENU Key. The Page Menu window is now displayed.
5)
Turn the FMS Knob to select ‘Disable Iridium Transmission’ in the menu list.
6)
Press the ENT Key. The Iridium transceiver is now disabled.
7)
To enable the Iridium transceiver, repeat steps 1 through 4, then select
‘Enable Iridium Transceiver’.
Vista de pagina 85
1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 173 174

Comentarios a estos manuales

Sin comentarios