
Garmin G1000 Cockpit Reference Guide for the Piper PA32
1-6
SECTION 1
SYSTEM OVERVIEW
OBS – Press to select OBS Mode on the CDI when
navigating by GPS.
CDI – Press to change navigation mode on the CDI
between GPS, VOR1, and VOR2.
DME (optional) – Press to display the DME Tuning
Window.
XPDR – Press to display the transponder and mode
selection softkeys.
STBY
– Press to select standby mode.
ON
– Press to select Mode A.
ALT
– Press to select altitude mode (Mode C).
GND
– Manually selects Ground Mode. The
transponder does not allow Mode A and
Mode C replies, but it does permit acquisition
squitter and replies to discretely addressed
Mode S interrogations.
VFR
– Press to automatically enter the VFR code
(1200 in the U.S.A. only).
CODE
– Press to display transponder code selection
softkeys 0-7.
0 through 7
– Press numbers to enter code.
Press the BACK Softkey to return
to the top-level softkeys.
Press the IDENT or BACK Softkey to return
to the top-level softkeys.
ALERTS
ALERTS
DME
ALERTS
Figure 1-5 Transponder Softkeys
BKSP
– Press to remove numbers entered one
at a time.
BACK
– Press to return to the previous level
softkeys.
IDENT
– Press to provide special aircraft
position identification to Air Traffic Control
(ATC) when the transponder is set to ON or
ALT.
IDENT
– Press to provide special aircraft position
identification to Air Traffic Control (ATC)
when the transponder is set to ON or ALT.
BACK
– Press to return to the previous level
softkeys.
IDENT – Press to provide special aircraft position
identification to Air Traffic Control (ATC) when
the transponder is set to ON or ALT.
TMR/REF – Press to display the Timer/References
Window.
NRST – Press to display the Nearest Airports
Window.
ALERTS – Press to display the Alerts Window.
Comentarios a estos manuales