
Garmin G1000 Cockpit Reference Guide for the Piper PA-34-220T Seneca
190-01405-00 Rev. A
Appendix
122
Flight
InstrumentsEIS
Nav/Com/
XPDR/AudioGPS Nav
Flight
PlanningProcedures
Hazard
Avoidance
Additional
Features
Abnormal
OperationAnnun/AlertsAppendixIndex
3)
Insert the updated Supplemental Data Cards into the bottom card slot of
the MFD and PFDs. The Supplemental Data Card containing the FliteCharts
or ChartView database is inserted in the MFD.
4)
Apply power to the system, check that the databases are initialized and
displayed on the power-up screen. A ‘Verifying’ message may be seen.
If this message is present, wait for the system to finish loading before
proceeding to step 5.
5)
Acknowledge the Power-up Page agreement by pressing the ENT Key or
the right most softkey.
6)
Turn the large FMS Knob to select the AUX Page group on the MFD.
7)
Turn the small FMS Knob to select the System Status Page.
8)
Press the Display Database Selection Softkey to show database information
for each display (MFD1 DB, PFD1 DB, or PFD2 DB). Verify the correct
database cycle information is shown for each database for each display.
9)
Remove power from the system.
Loading the Jeppesen Navigation Database as the Active Navigation
Database
The Jeppesen Navigation Database that is loaded to internal memory as the active
database will be used by the system.
NOTE: Loading the Jeppesen Navigation Database as the active database
prior to its effective date will result in the expiration date on the power-up
screen and the effective date on the AUX-System Status Page being displayed
in yellow.
NOTE: After the navigation database is loaded or copied, the top SD card
may be removed.
1)
With the system OFF, insert the SD card containing the new navigation database
version into the top card slot of the display (PFD1, PFD2 or MFD) to be updated
(label of SD card facing left).
2)
Turn the system ON. A prompt is displayed in the upper left corner of the
display:
Comentarios a estos manuales