Garmin GHP 10 System Manual de instalación descargar pdf (Pagina 4)

4 GHP 10 Installation Instructions



The GHP 10 autopilot system includes multiple cables. These cables

connect the components to power, to each other, to an alarm, and to

optional devices.



This cable connects the CCU to the ECU. A portion of this cable

contains color-coded wires with bare ends. These wires connect the

CCU to the alarm and to the yellow wire from the GHC 20.



When installing the GHP 10 system, you may need to mount the

CCU farther than 16 ft. (5 m) from the ECU. Garmin offers optional

replacement or extension cables for purchase if this is necessary.

 

Replacement 32 ft. (10 m)

Replacement 66 ft. (20 m)

Extension 16 ft. (5 m)

Extension 50 ft (15 m)

Extension 82 ft. (25 m)

Contact your local Garmin dealer or Garmin Product Support for

ordering information.



The alarm provides audible alerts from the GHP 10 (page 11).



This cable powers the ECU (page 10).



This cable connects the GHC 20 to the yellow wire of the CCU, and to

the same ground as the ECU (page 12). This cable can also be used to

connect the GHC 20 to optional NMEA 0183-compatible devices (page

14).



The NMEA 2000 cables connect the CCU and the GHC 20 to the

NMEA 2000 network. Either connect the CCU and the GHC 20 to an

existing NMEA 2000 network using the included T-connectors and drop

cables, or use all of the included NMEA 2000 cables and connectors to

build a NMEA 2000 network on your boat if needed (page 12).

➊

➋

➌ ➍ ➎

➊

NMEA 2000 drop cable, 6 ft. (2 m) (×2)

➋

NMEA 2000 power cable

➌

NMEA 2000 T-connector (×3)

➍

NMEA 2000 terminator, male

➎

NMEA 2000 terminator, female



NMEA 2000 extension cables are available if needed. Contact

your local Garmin dealer or Garmin Product Support for ordering

information.



If your tachometer source is a direct alternator connection or other

signal larger than 12 Vdc, or if you sporadically receive tachometer

errors, install an external tachometer lter (Garmin part number: 010-

11399-00), not included. Contact your local Garmin dealer or Garmin

product support for ordering information.



• Safety glasses

• Drill and drill bits

• 3

in. (90 mm) hole saw

• Wire cutters/strippers

• Phillips and at screwdrivers

• Cable ties

• Waterproof wire connectors (wire nuts) or heat-shrink tubing and a

heat gun

• Marine sealant

• Portable or handheld compass (to test for magnetic interference

when determining the best location to install the CCU)

• Anti-seize lubricant (optional)

NOTE: Mounting screws are provided for the GHC 20, for the

CCU, for the ECU, and for the pump. If the provided screws are not

appropriate for the mounting surface, you must provide the correct

types of screws.

1 2 3 4 5 6 7 8 9 ... 25 26

Comentarios a estos manuales

Sin comentarios

Garmin GHP 10 System Manual de instalación Pagina 4

Comentarios a estos manuales

Relacionado con productos y manuales para No Garmin GHP 10 System