Garmin GHP 10 System Manual de instalación descargar pdf (Pagina 9)

GHP 10 Installation Instructions 9



➊

➋

➌

➍

➎

NOTE: This diagram is for planning purposes only. Specic connection diagrams are included in the detailed installation instructions for each

component. Hydraulic connections are not shown in this diagram.

  

➊

GHC 20 In order for the autopilot to turn on, the yellow wire from the GHC 20 data cable must be connected to the yellow wire

from the CCU/ECU interconnect cable, and the black wire from the GHC 20 data cable must be connected to the

same ground as the ECU (page 12).

➋

CCU

The CCU must be installed in the front half of the boat,

no higher than 10 ft. (3 m) above the waterline.

➌

NMEA 2000 network The GHC 20 and the CCU must be connected to the NMEA 2000 network using the included T-connectors (page 12).

If there is not an existing NMEA 2000 network on your boat, you can build one using the supplied cables and

connectors (page 13).

➍

ECU The ECU can either be connected to a 12 or a 24 Vdc battery.

➎

12-24 Vdc battery The ECU can be connected to a 12–24 Vdc power source.

The NMEA 2000 power cable must be connected to a 9–16 Vdc power source.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 25 26

Sin comentarios

Garmin GHP 10 System Manual de instalación Pagina 9