Garmin GPSMAP 192C Manual de usuario descargar pdf (Pagina 101)

GPSMAP 192C Owner’s Manual 95

APPENDIX > MOUNTING THE GPSMAP 192C UNIT

To install the GPS antenna:

1. Screw the antenna directly onto the 1" x 14-thread mount.

2. Route the cable to the mounting location of the display unit.

Use the appropriate tie-wraps, fasteners, and sealant to

secure the cable along the route and through any bulkhead

or deck.

3. After the GPSMAP 192C unit is installed, connect the cable

to the antenna connector on the back of the display unit.

Make sure that you turn the antenna cable connector 1/4

turn clockwise to lock the cable into place.

Mounting the GPSMAP 192C Unit

The GPSMAP 192C’s compact, waterproof case is suitable for

mounting in exposed locations or at the nav station. The unit comes

with a gimbal bracket that can be used for surface or overhead

mounting. When choosing a location for the display unit, consider

the following conditions:

• There should be at least a 3" (7 cm) clearance behind the

case to allow connection of the antenna (external antenna

only), power/data cables.

• The mounting surface should be heavy enough to support the

unit and protect it from excessive vibration and shock.

• For GPSMAP 192C units with the built-in internal bail

mount antenna, it should be mounted in a location that

has the clearest, most unobstructed view of the sky in all

directions to ensure the best reception. Avoid mounting the

unit where it is blocked by the boat’s superstructure, a radar

arch, or mast.

NOTE: The temperature range for the GPSMAP 192C is 5°F

to 158°F (-15°C to 70°C). Extended exposure to temperatures

exceeding this range (in storage or operating conditions) can

cause failure of the display. This type of failure and related

consequences are NOT covered by the manufacturer’s limited

warranty.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 123 124

Sin comentarios

Garmin GPSMAP 192C Manual de usuario Pagina 101