Garmin SA01933LA_D Manual de instrucciones descargar pdf (Pagina 20)

Instructions for Continued Airworthiness G600, GNS 530W, GNS 430W, 190-01080-05 Rev. 2

GMA 347, GTX 330D, GMX 200, WSI AV-200 Cessna 208/208B Page 20 of 29

Configure the GMA 347 in accordance with Section 4 of the applicable Modification Summary.

2.7.8.3 Return to service

Perform a Transceiver Operational Check as described in Section 5 of the applicable Modification

Summary.

2.7.9 GMX 200

2.7.9.1 Removal

Insert a 3/32-inch hex drive tool into the access hole on the unit face. Unscrew the screw shaft. The unit

will be loosened and then may be pulled from the tube. No special extraction tools are required.

2.7.9.2 Installation

Slide the unit into the tube and hand-tighten the threaded screw shaft using a 3/32" hex. The unit will be

pulled into the tube by the shaft, and the connectors will fully engage. The back of the bezel must be flush

to the mounting tube.

Original GMX 200 is reinstalled

Verify that the unit power-up self-test sequence is successfully completed and no failure messages are

annunciated. No configuration is required.

Replacement or repaired GMX 200 is installed

Verify software version and perform post installation checkout procedures in accordance with the

applicable Modification Summary. No configuration is required.

GMX 200 Configuration Module is Replaced

If the GMX 200 Configuration Module is replaced, then the configuration setup will need to be performed.

Refer to Section 4 of the appropriate Modification Summary for GMX 200 configuration instructions.

2.7.10 WSI AV-200 and WSI Antenna

2.7.10.1 Removal

To remove the WSI AV-200 or WSI antenna gain access to the unit (see Avionics Installation, GNS

530(W), GMX200, WSI AV-200, 150 P/N 005-00368-12/-13). For the WSI AV-200 loosen mounting screw

and disconnect wiring, then remove unit from mounting tray. For the WSI antenna remove the sealant

surrounding the antenna and the 4 screws that hold the antenna in place, then disconnect the coaxial

cable.

2.7.10.2 Installation

Installation of the WSI AV-200 is the reverse of removal.

To reinstall the WSI antenna:

1. Clean the antenna, doubler, and aircraft skin of any existing sealant or other material.

2. Secure the antenna using the 4 8-32 screws and torque to 12-15 inch pounds.

3. Using sealing compound (PS700), run a bead of sealant along the antenna where it meets the

aircraft skin. Ensure the antenna connectors do not become contaminated with sealant.

4. Reconnect the coaxial cable to the antenna connector and ensure it is secure.

2.7.11 GTX 330D

2.7.11.1 Removal

1. Insert the hex drive tool into the access hole on the unit face and rotate counterclockwise until the

unit is forced out about 3/8 inch.

2. Pull the unit straight out of the rack.

2.7.11.2 Installation

1. Insert a 3/32” hex wrench into the access hole on the front panel.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 28 29

Comentarios a estos manuales

Sin comentarios

Garmin SA01933LA_D Manual de instrucciones Pagina 20

Comentarios a estos manuales

Relacionado con productos y manuales para Sistemas de intercomunicación de la puerta Garmin SA01933LA_D