Garmin SA01933LA_D Manual de instrucciones descargar pdf (Pagina 26)

Instructions for Continued Airworthiness G600, GNS 530W, GNS 430W, 190-01080-05 Rev. 2

GMA 347, GTX 330D, GMX 200, WSI AV-200 Cessna 208/208B Page 26 of 29

Appendix A. Transponder/DME Cable Connector Removal & Replacement

The BNC connectors, if damaged, can be replaced individually as necessary without requiring complete

cable assembly replacement.

A.1 Transponder Cable Connectors

Table A-1 lists required tooling to accomplish the termination.

Table A-1. Transponder Cable Tooling

Item

Description / Part No.

Hex Die Tooling

Military P/N = M22520/5-35

-or-

Daniels P/N = Y137

Tool Frame

M22520/5-01 (HX4)

Hex Size

A Hex

Solder Temperature

750 – 800F

Termination Instructions, 90° Connectors (Ref Emteq Dwg ES-105-5):

1. Disconnect faulty connector from upper transponder antenna. Cut the connector off completely

using snips or diagonal cutters. Make every attempt to limit the amount of cable which is removed

along with the connector.

NOTE:

For proper transponder diversity performance,

all four cables must be within 12 inches total length of each other.

2. Slide on heat shrink labels, black adhesive heat shrink, and crimp tube. Installer is responsible

for remaking cable labels. Use existing cable label as a reference.

3. Strip the cable insulation according to the following diagram:

NOTE:

Take care not to nick the center conductor or shield braid.

Do not remove inner foil shield from dielectric.

4. Install cable insulator onto center conductor butting it up against cable dielectric, as shown:

1 2 ... 21 22 23 24 25 26 27 28 29

Sin comentarios

Garmin SA01933LA_D Manual de instrucciones Pagina 26