
Garmin G1000 Cockpit Reference Guide for the Cessna 350/400
190-00567-01 Rev. B
12-20
SECTION 12 – ANNUNCIATIONS
& ALERTS
GMU 44 Message Advisories
Message Comments
HDG FAULT
– AHRS1 magnetometer
fault has occurred.
A fault has occurred in the #1 GMU 44. Heading is flagged as invalid. The AHRS
uses GPS for backup mode operation. The G1000 system should be serviced.
MANIFEST
– GMU1 software
mismatch, communication halted.
The GMU 44 has incorrect software installed. The G1000 system should be
serviced.
GDL 69A Message Advisories
Message Comments
GDL69 CONFIG
– GDL 69 config
error. Config service req’d.
GDL 69 configuration settings do not match those of backup configuration
memory. The G1000 system should be serviced.
GDL69 FAIL
– GDL 69 has failed. A failure has been detected in the GDL 69. The receiver is unavailable. The
G1000 system should be serviced
MANIFEST
– GDL software mismatch,
communication halted.
The GDL 69 has incorrect software installed. The G1000 system should be
serviced.
GDC 74A Message Advisories
Message Comments
MANIFEST
– GDC1 software
mismatch, communication halted.
The GDC 74A has incorrect software installed. The G1000 system should be
serviced.
GCU 476 Message Advisories
Message Comments
GCU CNFG
– GCU Config error.
Config service req’d.
GCU 475 configuration settings do not match those of backup configuration
memory. The G1000 system should be serviced.
GCU FAIL
– GCU is inoperative. A failure has been detected in the GCU 475. The GCU 475 is unavailable.
MANIFEST
– GCU software mismatch,
communication halted.
The GCU 475 has incorrect software installed. The G1000 system should be
serviced.
GCU KEYSTK
– GCU [key name] Key
is stuck.
A key is stuck on the GCU 475 bezel. Attempt to free the stuck key by pressing it
several times. The G1000 system should be serviced if the problem persists.
Comentarios a estos manuales