
Garmin G1000 Cockpit Reference Guide for the Quest KODIAK 100
190-00645-05 Rev. A
Appendix
99
Flight
Instruments EIS
Nav/Com/
XPDR/Audio GPS Nav
Flight
Planning Procedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation Annun/Alerts Appendix Index
Level 1 Level 2 Level 3
Description
DCLTR (3)
Selects desired amount of map detail;
cycles through declutter levels:
DCLTR (No Declutter): All map
features visible
DCLTR-1: Declutters land data
DCLTR-2: Declutters land and SUA
data
DCLTR-3: Removes everything except
the active flight plan
SHW
CHRT
When available, displays optional
airport and terminal procedure charts
CHKLIST
When available, displays optional
checklists
LOADING UPDATED DATABASES
CAUTION: Never disconnect power to the system when loading a database.
Power interruption during the database loading process could result in main-
tenance being required to reboot the system.
NOTE: When loading database updates, the ‘DB Mismatch’ message will
be displayed until database synchronization is complete, followed by turning
system power off, then on. Synchronization can be monitored on the AUX-
SYSTEM STATUS Page.
In some cases it may be necessary to obtain an unlock code from Garmin in order
to make the database product functional. It may also be necessary to have the system
congured by a Garmin authorized service facility in order to use some database
features.
If an error occurs during synchronization, an error message will be displayed,
followed by the affected display in the Sync Status section of the Database Window. If
synchronization completes on one display, but an error occurs on another, the error
message will be displayed with the affected displays listed after it. When an error
message is displayed, the problem must be corrected before synchronization can be
completed. A power cycle is required to restart synchronization when ‘Card Full’ or
‘Err’ is shown.
Comentarios a estos manuales