
Garmin G1000 Cockpit Reference Guide for the Quest KODIAK 100
190-00645-05 Rev. A
Appendix
103
Flight
Instruments EIS
Nav/Com/
XPDR/Audio GPS Nav
Flight
Planning Procedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation Annun/Alerts Appendix Index
13)
Turn system power OFF.
14)
Remove the SD card from the top card slot of the MFD.
15)
Turn system power ON.
16)
Press the ENT Key to acknowledge the startup screen.
17)
Turn the large FMS Knob to select the AUX Page group on the MFD.
18)
Turn the small FMS Knob to select the System Status Page.
19)
Press the Display Database Selection Softkey to show standby navigation
database information for each display (MFD1 DB, PFD1 DB, PFD2 DB).
Verify the correct standby navigation database cycle information is shown
for each display.
Magnetic Field Variation Database Update
At startup, the system compares this version of the MV DB with that presently being
used by each AHRS (GRS1 and GRS2). If the system determines the MV DB needs
to be updated, a prompt is displayed on the Navigation Map Page, as shown in the
followinggure.Note,inthefollowingexample,GRS1istherstAHRS to indicate
an update is available. In actuality, this is dependent on which AHRSistherstto
report status to the system. GRS2 may be displayed before GRS1. The order is not
important, only that both AHRS be updated.
GRS1 Magnetic Field Variation Database Update Prompt
Loading the magnetic field variation database update:
1)
With ‘OK’ highlighted, as shown in the previous figure, press the ENT Key
on the MFD. A progress monitor is displayed as shown in the following
figure.
Comentarios a estos manuales