Garmin Software Version 0563.32 Guía de usuario Pagina 172

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 182
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 171
Garmin G1000 Cockpit Reference Guide for the Cessna Nav III
190-00384-13 Rev. B
Appendix
154
Flight
InstrumentsEIS
Nav/Com/
XPDR/AudioAFCSGPS Nav
Flight
PlanningProcedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
AlertsAppendixIndex
Updating Terrain, Airport Terrain, FliteCharts, and ChartView Databases
The Terrain, and Airport Terrain databases must be copied to both Supplemental
Data Cards. The FliteCharts or ChartView databases should be copied to the MFD
Supplemental Data Card only:
1)
With system power OFF, remove the Supplemental Data Card from the
bottom card slot of the MFD and PFD.
2)
Update the terrain, airport terrain and/or FliteCharts or ChartView
databases on the appropriate Supplemental Data Cards.
3)
Insert the updated Supplemental Data Cards into the bottom card slot of
the MFD and PFD.
4)
Apply power to the system, check that the databases are initialized and
displayed on the power-up screen. A ‘Verifying’ message may be seen.
If this message is present, wait for the system to finish loading before
proceeding to step 5.
5)
Acknowledge the Power-up Page agreement by pressing the ENT Key or
the right most softkey.
6)
Turn the large FMS Knob to select the AUX Page group on the MFD.
7)
Turn the small FMS Knob to select the System Status Page.
8)
Press the Display Database Selection Softkey to show database information
for each display (MFD1 DB or PFD1 DB). Verify the correct database cycle
information is shown for each database for each display.
9)
Remove power from the system.
Loading the Jeppesen Navigation Database as the Active Navigation
Database
The Jeppesen Navigation Database that is loaded to internal memory as the active
database will be used by the system.
NOTE: Loading the Jeppesen Navigation Database as the active database
prior to its effective date will result in the expiration date on the power-up
screen and the effective date on the AUX-System Status Page being displayed
in yellow.
NOTE: After the navigation database is loaded or copied, the top SD card
may be removed.
Vista de pagina 171
1 2 ... 167 168 169 170 171 172 173 174 175 176 177 ... 181 182

Comentarios a estos manuales

Sin comentarios