Garmin Software Version 0563.32 Guía de usuario Pagina 67

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 182
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 66
Garmin G1000 Cockpit Reference Guide for the Cessna Nav III
190-00384-13 Rev. B 49
Procedures
Flight
Instruments EIS
Nav/Com/
XPDR/Audio AFCS GPS Nav
Flight
Planning Procedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
Alerts Appendix Index
LOAD AND/OR ACTIVATE AN APPROACH PROCEDURE
NOTE: If certain GPS parameters (SBAS, RAIM, etc.) are not available, some
published approach procedures for the desired airport may not be displayed
in the list of available approaches.
1)
Press the PROC Key.
2)
Turn the large FMS Knob to highlight ‘SELECT APPROACH’.
3)
Press the ENT Key. A list of available approaches for the destination airport
is displayed.
4)
Turn either FMS Knob to highlight the desired approach.
5)
Press the ENT Key. A list of available transitions for the selected approach
procedure is now displayed.
6)
Turn either FMS Knob to select the desired transition. The “Vectors”
option assumes vectors will be received to the final course segment of
the approach and will provide navigation guidance relative to the final
approach course.
7)
Press the ENT Key. The cursor moves to the MINIMUMS field.
8)
If desired, the DA/MDA for the selected approach procedure may be
entered and displayed on the PFD. Turn the small
FMS
Knob in the
direction of the green arrow to change the display from OFF to BARO, or
TEMP COMP.
9)
Press the
ENT
Key. The cursor moves to the altitude field. Turn the small
FMS
Knob to enter the published DA/MDA for the selected approach
procedure.
10)
Press the
ENT
Key. If BARO, or OFF was selected step 8, proceed to step
11. If TEMP COMP was selected in step 8, the cursor moves to the ‘TEMP
AT....” field. Turn the small
FMS
Knob to enter the temperature at the
destination airport. The temperature compensated altitude minimum is
displayed below the previously enter minimum altitude value.
11)
Press the ENT Key. ‘LOAD? or ACTIVATE?’ is now displayed with ‘LOAD?’
highlighted.
Vista de pagina 66
1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 181 182

Comentarios a estos manuales

Sin comentarios