Garmin Software Version 1983.00 Guía de usuario Pagina 55

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 144
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 54
Garmin G1000 Cockpit Reference Guide for the Piper PA-44-180 Seminole
190-01462-01 Rev. A 37
Flight Planning
Flight
Instruments EIS
Nav/Com/
XPDR/Audio AFCS GPS Nav
Flight
Planning Procedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
Alerts Appendix Index
Creating a user-defined hold at a Direct To waypoint:
1)
Press a Direct-to Key and set up the Direct To waypoint as desired, but
select ‘HOLD?’ instead of ACTIVATE?’ when finished (MFD or PFD).
2)
Use the FMS Knobs to edit the entry course, and press the ENT Key.
3)
Use the small FMS Knob to select ‘INBOUND’ or ‘OUTBOUND’ course
direction, and press the ENT Key.
4)
Use the small FMS Knob to select ‘TIME’ or ‘DIST’ length mode, and press
the ENT Key.
5)
Use the FMS Knobs to edit the length, and press the ENT Key.
6)
Use the small FMS Knob to select ‘RIGHT’ or ‘LEFT’ turn direction, and
press the ENT Key.
7)
Use the FMS Knobs to edit the Expect Further Clearance Time (EFC TIME),
and press the ENT Key.
8)
Press the ENT Key while ACTIVATE?’ is highlighted to activate the Direct To
with the user-defined hold defined at the Direct To waypoint.
Removing a user-defined hold (created at an active flight plan
waypoint):
1)
Press the FPL Key to display the Active Flight Plan Page (MFD) or the Active
Flight Plan Window (PFD).
2)
Press the FMS Knob to activate the cursor (not required on the PFD) and
turn the large FMS Knob to highlight the HOLD waypoint.
3)
Press the CLR Key. A ‘Remove Holding Pattern?’ confirmation window is
displayed.
4)
Select ‘OK’ and press the ENT Key. The holding pattern is removed from
the active flight plan. Select ‘CANCEL’ and press the ENT Key to cancel the
removal of the holding pattern.
Removing a user-defined hold (created at the aircraft present position
or at a Direct-To waypoint):
1)
Press the Direct To Key to display the DIRECT TO Window (PFD or MFD).
2)
Press the MENU Key to display the PAGE MENU with the cursor on the
‘Cancel Direct To NAV’ selection.
3)
Press the ENT Key. The holding pattern is removed.
Vista de pagina 54
1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 143 144

Comentarios a estos manuales

Sin comentarios