
Garmin G1000 Cockpit Reference Guide for the Cessna Nav III
190-00384-08 Rev. A
10-3
SECTION 10 – HAZARD
AVOIDANCE
Change the viewing mode between 360
˚
and
120˚:
1)
Select the Stormscope Page.
2)
Press the
VIEW
Softkey. The
360
and
ARC
Softkeys
are displayed. Press the 360 Softkey to display
a 360˚ viewing area or press the ARC Softkey to
display a 120˚ viewing area.
Press the
CLEAR
Softkey to remove all Stormscope
lightning data from the display.
10.3 XM WEATHER (SERVICE OPTIONAL)
WARNING: XM Weather is not intended to
be used for hazardous weather penetration.
Weather information provided by XM Radio
Service is approved only for weather avoidance,
not penetration.
1)
From the Navigation Map Page, press the
MAP
Softkey.
2)
Press the
NEXRAD or XM LTNG
Softkey to display
the desired weather. Press the applicable softkey
again to remove weather data from the Navigation
Map Page.
Figure 10-7 Navigation Map Page Displaying NEXRAD Weather
NOTE: Weather is not displayed on the Navigation
Map Page at zoom levels less than 10 nm.
Displaying METAR and TAF information on the
Airport Information Page
1)
Turn the large
FMS
Knob to select the WPT Page
Group.
2)
Turn the small
FMS
Knob to select the Airport
Information Page.
3)
Press the WX Softkey to display METAR and TAF
text (METAR and TAF information is updated every
12 minutes).
Figure 10-8 METAR and TAF Text Displayed on the
Airport (Weather) Information Page
METAR
Text
TAF
Text
WX
Softkey
Comentarios a estos manuales