Garmin Software Version 0719.00 Guía de usuario Pagina 18

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 228
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 17
Garmin G1000 Cockpit Reference Guide for the Socata TBM 850
190-00708-00 Rev. A
1-4
SECTION 1
SYSTEM OVERVIEW
1.2 CONTROLS ASSOCIATED WITH THE
MFD
The controls for the MFD (GDU 1500) are located on
both the MFD bezel and the MFD Control Unit (GCU
475). The bottom portion of the MFD bezel features 12
softkeys that are designed to perform various functions
depending upon the specific page being displayed. These
softkeys are discussed throughout the Pilot’s Guide docu-
mentation.
The following list provides an overview of the controls
located on the MFD Control Unit (see Figure 1-2):
6
7
8
9
Figure 1-2 MFD Control Unit (GCU 475)
3 4 521
13 12 11 1014
1
Dual FMS Knob
Flight Management
System Knob. This knob selects the MFD
page to be viewed; the large
knob selects
a page group (MAP, WPT, AUX, NRST),
while the small
knob selects a specific page
within the page group. Pressing the
FMS
Knob
turns the selection cursor ON and OFF. When
the cursor is ON, data may be entered in the
applicable window by turning the small and
large
knobs. In this case, the large
knob moves
the cursor on the page, while the small
knob
selects individual characters for the highlighted
cursor location.
2
Direct-to Key ( )
Allows the user to
enter a destination waypoint and establish a
direct course to the selected destination (the
destination is either specified by the identifier,
chosen from the active route, or taken from the
map pointer position).
3
FPL Key
Displays the active Flight Plan Page
for creating and editing the active flight plan, or
for accessing stored flight plans.
4
MENU Key
Displays a context-sensitive list
of options. This list allows the user to access
additional features or make setting changes that
relate to particular pages.
5
PROC Key
Gives access to IFR departure
procedures (DPs), arrival procedures (STARs)
and approach procedures (IAPs) for a flight
plan. If a flight plan is used, available
procedures for the departure and/or arrival
airport are automatically suggested. Theses
procedures can then be loaded into the active
flight plan. If a flight plan is not used, both the
desired airport and the desired procedure may
be selected.
6
Joystick
Changes the map range when rotated.
Activates the map pointer when pressed.
7
Alphanumeric Keys
Allow the user to enter
data quickly, without having to select individual
characters with the
FMS
Knob.
Vista de pagina 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 227 228

Comentarios a estos manuales

Sin comentarios