Garmin Software Version 0719.00 Guía de usuario Pagina 69

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 228
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 68
Garmin G1000 Cockpit Reference Guide for the Socata TBM 850
190-00708-00 Rev. A
SECTION 6 – AUTOMATIC
FLIGHT CONTROL
6-3
6.3 COMMAND BARS
Upon activation of the flight director, Command Bars
are displayed in magenta on the PFDs as single cues or
cross pointers. The Aircraft Symbol (in yellow) changes to
accommodate the Command Bar format; the Command
Bars do not override the Aircraft Symbol. The single-cue
Command Bars (Figure 6-3) move together vertically to
indicate pitch commands and bank left or right to indicate
roll commands. Command Bars displayed as a cross
pointer (Figure 6-4) move independently to indicate pitch
(horizontal bar) and roll (vertical bar) commands. Both
PFDs show the same Command Bar format. Command
Bar format may only be changed while on the ground.
Figure 6-3 Single-cue Command Bars
Command Bars
Aircraft Symbol
Figure 6-4 Cross-pointer Command Bars
Command Bars
Aircraft Symbol
The Command Bars are not displayed if attitude
information sent to the flight director is invalid or
unavailable, pitch exceeds +30˚/-20˚, or bank exceeds
65˚.
Figure 6-5 Changing Command Bar Format
Changing Command Bar Format
1)
Select the AUX-SYSTEM SETUP Page as shown
in Figure 6-5.
2)
Press the FMS Knob to activate the cursor.
3)
Turn the large FMS Knob place the flashing
cursor in the FLIGHT DIRECTOR-FORMAT
ACTIVE field.
4)
Turn the small FMS Knob to display the
selection window as shown in Figure 6-5.
5)
Turn the small FMS Knob to select SNGL QUE
which displays the Command Bars as a single
cue.
Or
:
Select X POINTR to display Command Bars as
a cross pointer.
6)
Press the ENT Key.
Vista de pagina 68
1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 227 228

Comentarios a estos manuales

Sin comentarios