
Garmin G1000 Cockpit Reference Guide for the Socata TBM 850
190-00708-00 Rev. A
SECTION 6 – AUTOMATIC
FLIGHT CONTROL
6-22
Selecting LOC Approach Mode
1)
Ensure a valid localizer frequency is tuned.
2)
Ensure that LOC is the selected navigation
source (use the CDI Softkey to cycle through
navigation sources if necessary).
3)
Press the APR Key.
Or
:
1)
Ensure that GPS is the selected navigation
source (use the CDI Softkey to cycle through
navigation sources if necessary).
2)
Ensure a LOC/ILS approach is loaded into the
active flight plan.
3)
Ensure the corresponding LOC frequency is
tuned.
4)
Press the APR Key.
If the following occurs, the flight director reverts to
Roll Hold Mode (wings rolled level):
• Approach Mode is active and a Vectors-To-Final is
activated
• Approach Mode is active and Navigation source is
manually switched
• GPS Navigation Mode is active and the FAF is
crossed after the automatic navigation source switch
from GPS to LOC
Changing the Selected Course
The Selected Course on each PFD is controlled using
the CRS1 and CRS2 knobs. Pressing the CWS Button
and hand-flying the aircraft does not change the Selected
Course while in Approach Mode. The autopilot guides
the aircraft back to the Selected Course (or GPS flight
plan) when the CWS Button is released.
Comentarios a estos manuales