
Garmin G1000 Pilot’s Guide for Cessna Nav III190-00498-00 Rev. A
8-9
The Traffic Map Page (Figure 8-6) controls the source
of TAS traffic data on the Navigation Map Page. NOTE:
When the G1000 is configured for TAS, the system
only receives TAS traffic. Otherwise, if TAS is not con-
figured, the system provides TIS traffic data.
To select the Traffic Map Page:
1. Turn the
large FMS
knob until the Map Page
group is selected.
2. Turn the
small FMS
knob until the Traffic Map
page is selected.
FAILURE RESPONSE
Errors indicated by a FAILED screen prevent contin-
ued use of the KTA 870 interface. See the KTA 870 Pilot’s
Guide for detailed information on Failure Response.
DESCRIPTION OF TRAFFIC ADVISORY
CRITERIA
For a description of Traffic Advisory System criteria
and display interpretation refer to the KTA 870 Pilot’s
Guide.
USER-INITIATED TEST
NOTE: A user initiated test can only be performed
when the system is in standby or failed mode.
To perform a user-initiated test:
1. Press the
TEST
softkey or use the menu to select
‘Test Mode’. Self-test is best accomplished
with the range set to 2 and 6 nm, and will
last approximately 8 seconds. The following
is displayed when a user-initiated test is per-
formed:
• A Traffic Advisory (yellow circle) appears
at 9 o’clock, range of 2 miles, 200 feet
below and climbing.
• Proximity Traffic (solid white diamond)
appears at 1 o’clock, range 3.6 miles,
1000 feet below, descending.
• Non-Threat traffic (open white diamond)
appears at 11 o’clock, range of 3.6.
miles, flying level 1000 feet above.
OPTIONAL EQUIPMENT
Comentarios a estos manuales