Garmin Legacy Software Versions Guía de usuario Pagina 88

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 364
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 87
Garmin G1000 Pilot’s Guide for Cessna Nav III 190-00498-00 Rev. A
3-8
NAV/COM
3.3 NAV OPERATION
FREQUENCY RANGE
The NAV radios receive in the VOR/ILS frequency range
of 108.00 to 117.95 MHz with 50 kHz spacing. The NAV
Frequency window displays the following information:
NAV1 and NAV2 active and standby frequencies
NAV1 and NAV2 identifier indication (if the Morse
code identifier is received by the system)
Color-coded indication of the selected NAV radio
Morse code identifier status
MORSE CODE IDENTIFIER
Press the VOL/PUSH ID knob to turn the Morse code
identifier ON and OFF. When the identifier is ON, a
white ID indication appears to the left of the active NAV
frequency, and the Morse code is heard on the NAV audio.
The VOR/LOC Morse code identifier is displayed next to
the active NAV frequency.
When the identifier is OFF, the ID indication disappears
and the Morse code is off.
NAV audio is available with the ID filtered out for
listening to HIWAS and FSS transmissions on VOR
stations.
NAV section
of the audio
panel
NAV2 radio is selected on the
audio panel. The Morse code
identifier for the GHM VOR
can be heard.
Figure 3-16 Morse Code Identifier Audio
NAV RADIO SELECTION FOR NAVIGATION
The desired NAV radio is selected for navigation by
pressing the CDI softkey located on the PFD. The three
navigation modes that can be selected are:
VOR1 (or LOC1) If NAV1 is selected, a single
green arrow (shown) labeled either VOR1 or
‘LOC1’ is displayed on the HSI and the active NAV1
frequency is displayed in green.
VOR2 (or LOC2) – If NAV2 is selected, a double
green arrow (not shown) labeled either ‘VOR2’ or
‘LOC2’ is displayed on the HSI and the active NAV2
frequency is displayed in green.
GPS If GPS mode is selected, a single magenta
arrow (not shown) appears on the HSI and neither
NAV radio is selected.
NOTE: In GPS mode, both active NAV
frequencies are displayed in white.
Figure 3-17 Selecting a NAV Radio
The NAV radio is
selected by the CDI
softkey.
Vista de pagina 87
1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 363 364

Comentarios a estos manuales

Sin comentarios