Garmin Legacy Software Versions Guía de usuario Pagina 62

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 364
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 61
190-00498-00 Rev. AGarmin G1000 Pilot’s Guide for Cessna Nav III2-32
PRIMARY FLIGHT DISPLAY
Flight ID
NOTE: If the G1000 is set to variable (“PFD
ENTRY”) and the ight ID entry field on the
Timer/References Window is not visible, the pilot
should contact a Garmin-authorized Service
Center.
Aircraft identification (ID) is transmitted from the GTX
33 transponder to the ground stations and other aircraft.
Theight ID is set to fixed (“SAME AS TAIL” and
“CONFIG ENTRY”) or variable (“PFD ENTRY”) at the time
of installation. The two fixed selections do not require any
action from the pilot. The variable (“PFD ENTRY”) flight
ID requires the pilot to enter the flight ID on the Timer/
References Window each time the G1000 is powered on.
To enter or change the Flight ID:
1. Press the
TMR/REF
softkey, then turn the
large
FMS
knob to highlight the flight ID field.
2. Turn the
FMS
knobs to enter the desired flight
ID.
3. Press the
ENT
key to update the flight ID.
Vspeeds and Vspeed Bug Status
NOTE: Default settings are automatically restored
when power is cycled.
Vspeed values for the aircraft can be found in the
Aircraft Flight Manual (AFM). The Vspeeds can be
changed and the Vspeed bug can be turned ON or OFF.
To change Vspeeds and turn the Vspeed
bug ON or OFF:
1. Press the
TMR/REF
softkey, then turn the
large
FMS
knob to highlight the field of the Vspeed
to be changed.
2. Turn the
small FMS
knob to select the desired
speed and press the
ENT
key (when a speed has
been changed, an asterisk appears next to the
speed). The ON/OFF field is now highlighted.
3. To change each setting individually, turn the
small FMS
knob in the direction of the green
arrowhead.
4. All Vspeed references can be changed simulta
-
neously by pressing the
MENU
key and selecting
All References ONor All References OFF’, then
by pressing the
ENT
key.
To restore all defaults:
1. From the Timer/References Window, press the
MENU
key.
2. Turn the
FMS
knob to highlight Restore
Defaults’ and press the
ENT
key.
3. Press the
TMR/REF
softkey to remove the window.
Vista de pagina 61
1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 363 364

Comentarios a estos manuales

Sin comentarios