Garmin Legacy Software Versions Guía de usuario Pagina 61

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 364
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 60
190-00498-00 Rev. A Garmin G1000 Pilot’s Guide for Cessna Nav III
2-31
PRIMARY FLIGHT DISPLAY
AUXILIARY WINDOWS
The lower right area of the PFD is a shared area that at
any one time can present the following windows:
TIMER/REFERENCES
NEAREST
DIRECT-TO
FLIGHT PLAN
PROCEDURES
Timer/References Window
NOTE: Refer to the Aircraft Flight Manual (AFM)
for limitations.
The Timer/References Window is enabled and disabled
by pressing the TMR/REF softkey.
Figure 2-47 Timer/References Window
The following Vspeeds and Vspeed bugs can be set
using the Timer/References Window:
Best glide speed reference
Best glide speed bug (ON, OFF)
Rotation speed reference (
V
R
)
V
R
bug (ON, OFF)
Best angle-of-climb speed reference (
V
X
)
V
X
bug (ON, OFF)
Best rate-of-climb speed reference (
V
Y
)
V
Y
bug (ON, OFF)
Generic Timer
The Generic Timer displays time (hr:min:sec), timer
count direction (UP or DOWN), and timer status (START,
STOP, or RESET).
To change the Generic Timer:
1. Press the
TMR/REF
softkey, then turn the
large
FMS
knob to select the time eld (hr:min:
sec).
2. Turn the
FMS
knobs to set the desired time,
then press the
ENT
key. The UP/DOWN field is
now highlighted.
3. Turn the
small FMS
knob to display the UP/
DOWN window.
4. Turn the
FMS
knob to select ‘UP’ or ‘DOWN’,
then press the
ENT
key. ‘START?’ is now high-
lighted.
5. Press the
ENT
key to START, STOP, or RESET the
timer (if the timer is counting DOWN, it must
be reset manually).
6. Press the
CLR
key or the
TMR/REF
softkey to
remove the window.
Figure 2-48 Timer Status Prompts
Vista de pagina 60
1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 363 364

Comentarios a estos manuales

Sin comentarios