Garmin Legacy Software Versions Guía de usuario Pagina 317

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 364
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 316
190-00498-00 Rev. A Garmin G1000 Pilot’s Guide for Cessna Nav III
9-9
ANNUNCIATIONS & ALERTS
9.7 G1000 SYSTEM MESSAGE
ADVISORIES
This section describes various G1000 system message
advisories. Some messages are issued due to an LRU or an
LRU function failure and are normally accompanied by a
corresponding red ‘X’ annunciation.
MFD & PFD Message Advisories
Message Comments
DATA LOST – Pilot stored data was
lost. Recheck settings.
The pilot profile data was lost. System reverts to default pilot profile and settings.
The pilot may reconfigure the MFD & PFD with preferred settings, if desired.
XTALK ERRORA flight display
crosstalk error has occurred.
The MFD and PFD are not communicating with each other. The G1000 system should
be serviced.
PFD1 SERVICE – PFD1 needs service.
Return unit for repair.
The PFD and/or MFD self-test has detected a problem. The G1000 system should be
serviced.
MFD1 SERVICE
– MFD1 needs
service. Return unit for repair.
PFD1 CONFIG – PFD1 configuration
error. Config service req’d.
The PFD and/or MFD configuration settings do not match backup configuration
memory. The G1000 system should be serviced.
MFD1 CONFIG – MFD1 configuration
error. Config service req’d.
SW MISMATCH – GDU software
mismatch. Xtalk is off.
The MFD and PFD have different software versions installed. The G1000 system
should be serviced.
MANIFEST – PFD1 software mismatch.
Communication halted.
The PFD and/or MFD has incorrect software installed. The G1000 system should be
serviced.
MANIFEST – MFD1 software
mismatch. Communication halted.
PFD1 COOLING – PFD1 has poor
cooling. Reducing power usage.
The PFD and/or MFD is overheating and is reducing power consumption by dimming
the display. If problem persists, the G1000 system should be serviced.
MFD1 COOLING – MFD1 has poor
cooling. Reducing power usage.
PFD1 “KEY” KEYSTK – Key is stuck.
A key is stuck on the PFD and/or MFD bezel. Attempt to free the stuck key by press
-
ing it several times. The G1000 system should be serviced if the problem persists.
MFD1 “KEY” KEYSTK – Key is stuck.
CNFG MODULE – PFD1 configuration
module is inoperative.
The PFD configuration module backup memory has failed. The G1000 system should
be serviced.
Vista de pagina 316
1 2 ... 312 313 314 315 316 317 318 319 320 321 322 ... 363 364

Comentarios a estos manuales

Sin comentarios