Garmin Software Version 0321.23 Manual Pagina 133

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 266
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 132
G1000 System Maintenance Manual – Diamond DA40/40F Page 5-1
190-00545-01 Revision G
5 TROUBLESHOOTING
This section provides instructions and guidance for G1000 system troubleshooting, as installed in the
Diamond Model DA 40.
IMPORTANT!
Sections 6, 7 and 8 provide detailed instructions on equipment removal, replacement,
configuration, and return-to-service testing. Anytime a G1000 component or LRU is
removed, swapped, or replaced, the technician must follow the procedures given in
Sections 6, 7 and 8 to ensure proper operation of the system.
Troubleshoot the G1000 system by first identifying, then isolating the specific failure to the responsible
LRU. There are several indications that the G1000 presents to the pilot or technician, showing overall
system condition. A course of action should be determined based on the information presented on the
display. This section shows possible scenarios likely to be encountered during normal operation and
gives troubleshooting guidance to the technician to resolve problems.
Figure 5-1. AUX – System Status Page
The AUX – System Status page is the 5
th
page in the AUX Page Group and displays the following
information for each LRU and sub-function:
Status: A green check is displayed for properly operating LRUs. A red ‘x’ appears when a LRU
fault is detected, or if the LRU is unavailable.
Serial Number: Each LRU serial number is displayed (functions such as GPS and GS are
contained within an LRU; therefore, serial numbers are not shown for these).
Current SW Version Loaded.
When troubleshooting, first check to ensure that each LRU status is ‘green’ and that the correct software
is loaded in each unit. Additional airframe and database information is also displayed on this page.
Vista de pagina 132
1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 265 266

Comentarios a estos manuales

Sin comentarios