
G1000 System Maintenance Manual – Diamond DA40/40F Page 8-13
190-00545-01 Revision G
6. Press the NOSE DN key on the MFD twice. The command bars should command down and the
control stick should begin moving forward. Hold the controls and press CWS to re-center the
command bars and stop control stick movement.
7. With the Autopilot still engaged and the CWS button pressed, move the control stick to its aft
limit. Release the CWS button and apply continuous forward pressure, slowly moving the control
stick. After 1 or 2 seconds, the trim wheel should begin moving in a trim up direction.
8. Grip the control stick and press the CWS button. Trim motion should stop. Move the control
stick to the forward limit and release the CWS button. Now slowly pull back on the control stick.
After a similar delay, the trim wheel should begin to trim down. Relief pressure on the wheel and
the trim motion should stop. Check that the trim wheel is free to turn. Hold the control stick and
press the AP DISC switch to disconnect the Autopilot.
8.4 Maintenance Records
After conducting required return-to-service procedures in accordance with the Diamond DA 40 Airplane
Maintenance Manual, the aircraft may be returned to service.
Record the following information in appropriate aircraft maintenance logs:
• Part number of the G1000 software loader card used to perform software loading or software
updates.
• Record part and serial numbers of any LRU which was replaced.
• Record any database updates which were performed during maintenance.
• Any other applicable information related to the maintenance work performed on the aircraft.
Comentarios a estos manuales