
Page 7-12 G1000 System Maintenance Manual – Diamond DA40/40F
Revision G 190-00545-01
• AUDIO (1 or 2) – software file
• AUDIO CFG – configuration file
9. Once the files are selected press the LOAD softkey.
10. When the upload is complete, press the ENT key to select OK in the upload complete window.
11. Verify that each column indicates in green when the loading process has finished and
inspect the SUMMARY window as well to ensure that the load is successful.
12. Load the optional configuration files for optional equipment (i.e. ADF, DME, GDL59, etc.) that
list GIA (1 or 2) files in the PRODUCT window for them. Refer to the LRU to Configuration
File Relationship Summary Table in Section 3 to determine which option files need to be loaded
for the GIA (1 or 2) replacement based on the installed optional equipment in the aircraft. These
must be loaded in order for the optional equipment to function correctly.
13. After the software and configuration files are loaded, turn off the system and remove the G1000
system software loader card. Reinsert the supplemental database cards in the bottom slot of each
display. Be sure to insert the card removed from the MFD back into the MFD.
14. Continue to the GIA 63 Testing section.
7.3.2 GIA 63 Testing
Apply power to the G1000 and allow system to initialize.
On the PFD, open the ALERT window and verify there are no GIA MANIFEST or configuration error
messages.
GPS Signal Acquisition:
Figure 7-8. AUX – GPS STATUS Page (MFD)
The GIA 63(W) units should normally acquire a GPS navigation solution within 5 to 10 minutes of
startup, provided the aircraft is outside (or indoors with a GPS repeater). Select the GPS STATUS page
on the MFD (3
rd
page in AUX group). Two softkeys on the bottom of the display allow the user to toggle
between GPS 1 and GPS 2.
Comentarios a estos manuales