
G1000 System Maintenance Manual – Diamond DA40/40F Page 8-1
190-00545-01 Revision G
8 System Return to Service Procedure
8.1 Software Verification
After reinstalling any G1000 LRU, verify the correct LRU software part numbers and versions against the
numbers listed on the appropriate General Arrangement drawing (see Table 1-2).
1. Start the G1000 system in configuration mode.
2. The PFD’s System Status page shows a list of LRUs in the LRU window. Activate the
cursor and highlight the LRU window. Use the FMS knob to scroll through the list in the
window and select the following LRUs.
Table 8-1. Return To Service Software Check
LRU SW VER LRU SW VER
ADF 1
(5)
___________
GPS1 ___________
COM 1
(2)
___________ GPS2 ___________
COM 2
(2)
___________ GRS1 ___________
GDC1 ___________ GRS1 FPGA ___________
GDC1 FPGA ___________ GRS1 MV DB ___________
GDL 59
(6)
___________
GS 1 ___________
GDL 59 Router
(6)
___________
GS 2 ___________
GDL 59 Router FS
(6)
___________
GSA PTCH CTL
(1)
___________
GDL69 ___________ GSA PTCH MON
(1)
___________
GEA1 ___________ GSA PTCH TRM C
(1)
___________
GFC CERT GIA1
(1)
___________ GSA PTCH TRM M
(1)
___________
GFC CERT GIA2
(1)
___________ GSA ROLL CTL
(1)
___________
GFC CERT P C
(1)
___________ GSA ROLL MON
(1)
___________
GFC CERT P M
(1)
___________ GSR 1
(7)
None
GFC CERT PT C
(1)
___________ GTX1 ___________
GFC CERT PT M
(1)
___________ MFD1 ___________
GFC CERT R C
(1)
___________ MFD1 FPGA ___________
GFC CERT R M
(1)
___________ NAV 1
(3)
___________
GIA1 ___________ NAV 1 BB
(3)
___________
GIA1 AUDIO ___________ NAV 1 FPGA
(3)
___________
GIA2 ___________ NAV 2
(3)
___________
GIA2 AUDIO ___________ NAV 2 BB
(3)
___________
GMA1 ___________ NAV 2 FPGA
(3)
___________
GMU1 ___________ PFD1 ___________
GMU1 FPGA ___________ PFD1 FPGA ___________
Note 1 - GFC 700-equipped aircraft.
Comentarios a estos manuales