Garmin Software Version 0321.23 Manual Pagina 17

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 266
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 16
G1000 System Maintenance Manual – Diamond DA40/40F Page 1-7
190-00545-01 Revision G
IMPORTANT!
If the technician is unsure of the G1000 MDL configuration, perform the following
steps:
Check System Software Version
1. Power on the G1000 system by turning on the BAT master switch, then the AVIONICS MASTER
switch.
2. On the MFD power-up page, the G1000 system software version is displayed in the upper right corner
in the following format:
Diamond DA40 System XXXX.XX
-or-
Diamond DA40F System XXXX.XX
The system software version is also displayed at the AUX – SYSTEM STATUS page in the upper
right corner.
3. This system software version is the primary identifier of which G1000/GFC700 configuration is
installed. Refer to Table 1-1 for approved G1000 system software versions.
NOTE
The approved G1000 system software versions for this STC are listed in Table 1-1. If the
system software version differs from that shown in Table 1-1, investigate further to
determine which G1000 configuration is installed. Refer to the appropriate
G1000/GFC700 System Maintenance manual (see list of superseded manuals which may
apply in Section 1.1.1).
Check for GFC 700 AFCS Installation
To verify whether the GFC 700 AFCS is installed, do the following:
1. Check the G1000 MFD for dedicated AFCS mode control keys on the left side of the display (see
Figure 3-2).
2. Check the aircraft throttle lever for installation of a ‘Go Around’ (GA) button.
3. If the aircraft has these features installed, it is equipped with the Garmin GFC 700 autopilot.
4. The aircraft is either a -1 or a -2 MDL Configuration.
Check for WAAS Installation
To verify whether WAAS is installed, do the following:
1. On the MFD, go to the AUX – GPS STATUS page.
2. Check to see whether a softkey labeled SBAS is displayed. The SBAS softkey only appears if the
G1000 is equipped with GIA 63Ws.
3. If the SBAS softkey is present, the aircraft is a -1, -3, or a -5 MDL Configuration.
Vista de pagina 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 265 266

Comentarios a estos manuales

Sin comentarios