Garmin Software Version 0321.23 Manual Pagina 29

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 266
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 28
G1000 System Maintenance Manual – Diamond DA40/40F Page 2-3
190-00545-01 Revision G
2.2.3 GIA 63 or GIA 63W Integrated Avionics Unit (2)
NOTE
For MDL configurations -1,-3 and -5 only, this STC installation approves alternate part
number ‘-20’ GIA63Ws. The installation of these units will require software version
0321.23 or later as well as mechanical and wire harness changes to relocate the GTX33
transponders (refer to Section 2.2.5). Refer to the applicable General Arrangement
Drawing listed in Table 1-2 for part number and software information.
Two Garmin GIA 63 IAUs provide VHF COM, NAV, GS, and GPS navigation functions to the G1000.
GIA 63W models include a GPS/WAAS engine. GIAs also serve as a communication interface to all
other G1000 LRUs in the system. Both GIAs are located remotely beneath the baggage compartment in a
sheetmetal enclosure. The #1 GIA is powered through the ‘Essential’ power bus and immediately powers
up when the aircraft master switch is turned on. The #2 GIA receives power through the ‘Main Avionics’
bus and powers up when the avionics master switch is turned on. Both GIA 63s interface to the following
equipment:
Existing VOR/LOC/Glideslope Antenna System
Existing VHF COM 1 & 2 Antennas
Existing Garmin GA56 GPS1 & 2 Antennas (GIA 63 only)
GA35 GPS/WAAS Antennas (GIA 63W only)
2.2.4 GEA 71 Engine/Airframe Unit
The Garmin GEA 71 Engine/Airframe Unit provides engine/airframe data to the G1000 system. Data
received from transducers/sensors is processed, then sent to GIA 63, and subsequently to the GDU 1040
MFD. In display reversionary mode, engine instrumentation is displayed on the PFD as well. The GEA
is located behind the instrument panel and is mounted in a vertical orientation. Power is received from
the ‘Essential’ power bus. The GEA interfaces to the following:
Manifold Pressure Sensor (MAP, DA 40 aircraft only)
Oil Pressure Sensor
Fuel Pressure Sensor
Tachometer Sensor
Oil Temperature Sensor
Fuel Flow Sensor
4 Cylinder Head Temperature (CHT) Sensors
4 Exhaust Gas Temperature (EGT) Sensors
Alternator Current Sensor
Existing Fuel Probes
Existing Pitot Heat System
Existing Open Door Detection Switches
Existing Starter Engage System
NOTE
STC SA01254WI-D provisions engine/airframe sensors for the Diamond DA 40 aircraft
only. For DA 40 F aircraft with fixed-pitch propellers, all engine sensors are provisioned
and installed per Diamond OAM 40-222.
Vista de pagina 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 265 266

Comentarios a estos manuales

Sin comentarios