
Page 3-32 G1000 System Maintenance Manual – Diamond DA40/40F
Revision G 190-00545-01
9. When the boot block software finishes loading, acknowledge the following prompt by pressing
the ENT key:
Figure 3-25. GIA Boot Block Upload Complete Page
10. The boot block update procedure is complete. On the MFD System Status Page, highlight GIA1
and GIA2 and verify both units are reporting ‘OK’ status and that the GIAS ONLINE field shows
two green boxes.
11. Remove the GIA Boot Block loader card from the PFD and re-insert the correct G1000/GFC700
Software Loader card.
12. Restart the PFD and MFD in configuration mode by cycling the PFD and MFD circuit breakers.
Hold the ENT key on both displays while they power up until the words INITIALIZING
SYSTEM appear in white. The PFD may show a prompt to load system software files. Press the
NO softkey or press CLR.
13. Continue with the software loading and configuration procedure and load any remaining files
according to the procedures in Section 3.5.5.
Comentarios a estos manuales