
G1000 System Maintenance Manual – Diamond DA40/40F Page 1-13
190-00545-01 Revision G
The following design drawings are carried over from the prerequisite previously approved STCs for
continued airworthiness purposes.
IMPORTANT!
Previous STC General Arrangement drawings, Required Equipment Lists, and
hardware/software equipment lists are obsolete and are now superseded by the new
General Arrangement drawings provided in Table 1-2. The following type design data
still applies to previously installed equipment.
Table 1-3. Previously Approved Type Design
Part Number Document STC#
005-00304-00
G1000 Install, Diamond DA40/40F SA01254WI-D
005-00336-17
Pitch Servo Installation, GFC700 AFCS, Diamond DA40/40F
SA01389WI
005-00336-18
Roll Servo Installation, GFC700 AFCS, Diamond DA40/40F
005-00336-19
Pitch Trim Servo Installation, GFC700 AFCS, Diamond DA40/40F
The following publications are recommended to be available during maintenance activities.
Table 1-4. Reference Publications
Part Number Document
005-00304-00
G1000 Install, Diamond DA40/40F
190-00492-08
Airplane Flight Manual Supplement: G1000 Synthetic Vision And Pathways Option
190-00492-09
Airplane Flight Manual Supplement: G1000 Electronic Stability and Protection (ESP)
Option for the Diamond DA40/DA40F
190-00492-10
Airplane Flight Manual Supplement: G1000 Integrated Avionics System with GFC 700
Automatic Flight Control System – Diamond Model DA40 & DA40F
190-00492-11
Airplane Flight Manual Supplement: G1000 Integrated Avionics System – Diamond
Model DA40 & DA40F
190-00492-12
Airplane Flight Manual Supplement: G1000 Integrated Avionics System – Diamond
Model DA40 & DA40F
190-00324-07
190-00324-08
190-00324-09
190-00324-10
190-00324-11
G1000/GFC700 DA 40 Cockpit Reference Guide*
190-00355-04
GDL 69/69A XM Satellite Radio Activation Instructions
190-00303-72
GSA8X/GSM85(A) Installation Manual
*See AFMS for correct CRG P/N required.
Comentarios a estos manuales